![]() In the case of the 4 Pin Molex/Auxiliary Connector pin-out no. SeaSonic uses a standard method of pin-outs for all their current PSUs for the following modular connectors used at the PSU socket:Ħ Pin Auxiliary Connector - used for 4 Pin Molex/Auxiliary Connectors and SATA Power Connectors ![]() As I mention Ad nauseum I recommend the Thermaltake Dr Power II which will check every cable on an ATX PSU. You should always double check these cables before use as incorrect pin-outs will cause component destruction. These are all likely to apply to future releases of SeaSonic PSUs until further notice and can easily be verified by inspecting the supplied cables in the case of those supplied with coloured cables or checking with a multi-meter for the all black cables supplied with some of the later revisions. Here is a graph to use and scan when you have a full pinout to get you started: ![]() The use of the graph is not needed and you make make your own as long as it is easy for others to read. I will add a nice graph that was made by someone from the MDPC Family for people to use and as people make their own pinouts we can add them by maker and model. If you run into problems or want info on on which methods to use please check out the Sleeving FAQ Located Here : Frequently Asked Sleeving Questions Therefore this video method was made by Lutro0 Customs a while ago and has been used by sleevers since. But for those that want to full OEM sleeve or make a short cable kit you will need to split the cables to make them the cleanest and easiest to use. Another way is to just shroud the PSU and then use extensions which is the cheapest way to go about it. Also the users that contribute to these pinouts needs to get credit for the time they have put into helping out the community - so if you use them they should be thanked on your build log and the thread linked out of courtesy.Ī lot of the power supply units these days have double pins which make the sleeving process harder, you can try to sleeve a double wire and stuff it into the ATX connector but this looks terrible so most sleevers use a double wire technique where they put the split in the back of the case or make a short set of OEM cables and then add a set of extensions to the end for a clean look. Please don't steal these pinouts for your own site/use without linking back to this thread as this thread will continue to be added to and pinouts verified. Please also note that you are using these pinouts with no guarantee from anyone on the accuracy, but if they are listed most likely they were used on the project they were for.Īnother note of caution that some PSU makers will consider your warranty void by removing the wires! I'd also suggest a Multi-Meter as a quick way of testing or doubling checking an individual pinout in the case of doubt. I recommend investing in a PSU Tester and personally use the Thermaltake Dr Power II as it tests the main cables on an ATX PSU including the 8 Pin PCI-E cable which many testers do not include. Even if you see your pinout on the list please make one for yourself anyhow as nothing in this thread is iron clad and it should be a prerequisite to sleeving your power supply no matter how many times you have sleeved! It is always recommended that you make a pinout of your own, no matter what, before you begin on a sleeving job - remember to make one for all cables. ![]() ![]() This will be a community project and everyone is encouraged to add to the repository. This will simply be a repository of Pinouts for people that are looking for them for their sleeving job. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |